No Rinse Sanitiser 500ml
An acid cleaner for Brewing and Surface Sanitising.
A blend of phosphoric and benzenesulfonic acid and isopropanol.
An excellent sanitiser for manual application.
Not recommended on soft metals because of the acid nature of this product.
Dilution: 0.2%, 10ml to 5 litres of water. Higher concentrations will require a potable rinse.
All surfaces should be cleaned and rinsed beforehand. Minimum contact time 2 minutes.
The solution should remain at a pH at 3.5 or below to maintain proper sanitizing level.
If using the diluted solution over time, check the pH regularly using pH papers.
Chemsan will go cloudy if it has been diluted with hard water. This is normal and provided
the pH of the solution is 3.5 or less the diluted Chemsan will still be effective.
Hand Utensils, Tanks, Vats, Homebrew use:
Scrape or pre-clean dirty surfaces.
Clean all surfaces using a suitable detergent, following label directions. Rinse with
potable water. Apply diluted solution on surfaces with a cloth, mop ,brush, sponge,
spray or by immersion. After 2 minutes contact time, drain solution thoroughly.
For all applications, allow to air dry, however surfaces must remain wet for at least
two minutes.
Do not rinse after Chemsan application
